Hi all,
I have been mulling doing this myself and just trying to gauge the difficulty. I am fairly handy do a lot of my own work on outboards but this is a bit of another animal. I know this topic has been discussed at length but I cannot find a written procedure, step by step, or youtube video (for this engine) anywhere. Wondering if anyone can point me in the right direction.
• Welcome to https://albinowners.net, home of Albin Owners Group!
• If you don't remember your password, use the I forgot my password link to reset it.
• Contact Us if you have any questions. If you're not receiving our email, include a phone number where we can text you.
• If you don't remember your password, use the I forgot my password link to reset it.
• Contact Us if you have any questions. If you're not receiving our email, include a phone number where we can text you.
FAQ:
• Membership information
• Burgees
• How to post photos
• Membership information
• Burgees
• How to post photos
Yanmar 6lpa mixing elbow replacement
Moderator: Jeremyvmd
-
alandry100
- Mate
- Posts: 16
- Joined: Thu Mar 25, 2021 5:25 pm
- Home Port: Portland, Maine
Yanmar 6lpa mixing elbow replacement
04' 28TE Kris Ann
-
Paddy
- Gold Member
- Posts: 197
- Joined: Thu May 16, 2013 3:04 pm
- Home Port: Freeport, NY
Re: Yanmar 6lpa mixing elbow replacement
Isn't bad if you are handy. I did the HDI replacement in a few hours. Need a good sized wrench for the water outlet and the clamps were 11mm. I only had an 11mm wrench but invested in an 11mm deep socket. Loosely fit everything, have a helper holding the gaskets in place and tighten up.
You do not have the required permissions to view the files attached to this post. To view images, please register for a free account.
2004 28TE