Rebuild raw water pump for 4D61

[Vic K]

All the rebuild kits I see for the 4D61 Johnson raw water pump only show one seal. Two seals came out of the pump; one on the engine side an oil seal and one on the impeller side a water seal. They were separated by a plastic device. Has anyone on this site actually rebuilt one of these pumps and can set me straight about the seals.
Thanks,

Vic

[abellch]

Just finished overhauling my raw water pump on a 6lpa. The pump is a Johnson and has the same seal configuration with the plastic spacer. The seals were 16x28x7 metric that I sourced from a local bearing supply house. (Fairly common seal) the seals face in opposite directions with the spacer between the faces. There was also a o-ring slinger on the shaft between the seal faces. If you check out "pump vendor" site they have excellent part lists and diagrams for most models

Chuck Abell.

[Vic K]

Chuck.
I looked up the diagram for the Johnson pump FSB9 1024119 and it only shows one seal. Am I looking in the wrong place?
Vic

[Vic K]

FYI: I just got an email from pump vendor and only one seal is in this pump. In the package with the old pump I need to rebuild is the old seal in two parts so it looked like there were two seals.