RPM gauge issue

Post by **mjohnh** » Mon Sep 01, 2014 5:48 pm

Well, mates...one more issue.....The RPM gauge, after about 1/2 hour to 1 hour of run time, sometimes...not every time......drops to "0" and does not recover......sometimes....it bounces up and down before it dies.......it is a "Brede" gauge.

Has anyone encountered this and what has been the fix? The engine is running unaffected at all times.......only 461 hours.

Thanks, again.

Post by **RobS** » Mon Sep 01, 2014 8:59 pm

Start with spade connectors at sensor on bell housing

Post by **mjohnh** » Mon Sep 01, 2014 9:48 pm

Rob: I am a newbie.....have no idea what you have said..........spade connector?.....bell housing.?? help with some interpretation...

Post by **RobS** » Tue Sep 02, 2014 10:29 am

Remember to try the search function, it is much easier to use on this site than on others - here's an old post, should give you what you need. Good luck.

viewtopic.php?f=7&t=2803&hilit=sender

Post by **mjohnh** » Tue Sep 02, 2014 1:47 pm

thanks, Rob

Albin Owners Group

Albin Owners Group

RPM gauge issue

RPM gauge issue

Re: RPM gauge issue

Re: RPM gauge issue

Re: RPM gauge issue

Re: RPM gauge issue