the thing that annoys me with just about any boat

[tomcat rio]

..no owners manual with locations of pumps, valves, etc. and no wiring schematics...
i really get torqued off when i come acress an inline fuze and have no idea what its for till i trace the wire to whatever system is using it.
...
albin is just as guilty of this as any other manufacturer.

[chiefrcd]

Yep...as you read around the forums you'll see that most of us have made similar comments. I did manage to get a number schematics of the systems on my 99 from my local Albin Dealer.

I have the following:

* Steering system
* pump systems, (bilge, raw water, livewell )
* freshwater,
* waste water,
* air conditiioning system,
* thru hull and sea cock locations,
* grey water drainage system,
* hot and cold water system,
* battery charging layout,
* bonding system,
* bowthruster set up,
* 12volt detail ( not too detailed however ),
* Fuel System Detail,
* Drive Train Detail,
* lifting locations detail
* hull to joint detail
* and the last drawing is of the bulkheads/hull/skeg with measurements.

These are all for a 1999 and they are several times copied but if any of these would help anyone I'd be glad to make copies and send them out.
I did find out that on at least the 1999 they did remove the coring at the thru hulls and fill them in with solid glass, according to the spec sheet.

[DougSea]

Chief, I'd REALLY like to get copies of those. I realize things probably changed between my 97 and your 99 but it would at least give me a strong starting point, I don't have any of the drawings you listed.

I'd be more than happy to reimburse you for the cost of copying and mailing!

Doug

[tomcat rio]

thanks, lemme know what you need

[chiefrcd]

I scanned them and they turned out pretty good.....
You can send me your e mail address at

ChiefRCD@comcast.net

I'll send them as a .zip file so you'll have to unzip them.