Adjusting Park Location on AFI Wiper Motors

[Jkraft]

Hi all, I am trying to understand how to adjust the park position on my motors. Currently, if looking at my motors, there is a single screw on the left hand side that attaches the motor to the boat. I was under the impression that once I pull the motor cover off that I can adjust the park position. How do I remove the cover? Do I need to remove the motor to do this or does it snap off somehow?

Thanks,

[carolmarie]

You must remove the motor, including the wiring. You will then see the face plate that is attached to the motor housing (6 screws, I think). You should Google the service sheet for the AFI motor and you will get a clear explication of how to change the park position. It’s pretty straight forward.
Remember to caulk the mounting hole when reassembling the motor to the hard top.
Don.

[Jkraft]

You must remove the motor, including the wiring. You will then see the face plate that is attached to the motor housing (6 screws, I think). You should Google the service sheet for the AFI motor and you will get a clear explication of how to change the park position. It’s pretty straight forward.
Remember to caulk the mounting hole when reassembling the motor to the hard top.
Don.

Thanks Don!

[MerryKate]

317646-11630.pdf