• Welcome to https://albinowners.net, the new home of Albin Owners Group!
• You will need to log in here, and you may want to bookmark this site. If you don't remember your password, use the I forgot my password link to reset it.
• All content has been transferred from our previous site.
• Contact Us if you have any questions or notice a problem. If you're not receiving our email, include a phone number where we can text you.
• You will need to log in here, and you may want to bookmark this site. If you don't remember your password, use the I forgot my password link to reset it.
• All content has been transferred from our previous site.
• Contact Us if you have any questions or notice a problem. If you're not receiving our email, include a phone number where we can text you.
FAQ:
• Membership information
• Burgees
• How to post photos
• Membership information
• Burgees
• How to post photos
Flag Pole Socket
-
robienick
- Deckhand
- Posts: 7
- Joined: Tue Feb 19, 2019 8:13 pm
- Home Port: weymouth, ma
Flag Pole Socket
I have a 28TE and would like to mount a flag pole socket on the transom. There are plenty of mounts for a flat deck surface, but none for the vertical transom. Does anyone know of a source for this type of mount?
-
Pitou
- Gold Member
- Posts: 2091
- Joined: Thu Feb 22, 2007 1:34 pm
- Home Port: Gloucester, MA
- Location: Essex, MA
Re: Flag Pole Socket
Recommended and sold to me by Ken Hilton at Standish when I bought my 28 TE from him back in 2006 was a Stainless Steel 30° Round Base by Whitecap. I put one on my 31TE as well.
This is your solution, but comes with the task of cutting the base diameter of your wooden flagpole to fit along with cutting an angle on the end to meet the 30 degree angle for full insertion. No big deal on a tablesaw. I also drilled a hole where the upper set screw is located in the base to add a safety pin.
This is your solution, but comes with the task of cutting the base diameter of your wooden flagpole to fit along with cutting an angle on the end to meet the 30 degree angle for full insertion. No big deal on a tablesaw. I also drilled a hole where the upper set screw is located in the base to add a safety pin.
You do not have the required permissions to view the files attached to this post. To view images, please register for a free account.
kevinS
>><<>>;>
Former Boats:
- 2006 31TE / Hull# 221
Cummins QSC 8.3 / 500 hp
December '13 - April '23
- 2002 / 28TE / Hull# 614
Cummins 6BTA 370 hp / Alaskan Bulkhead
April '04 ~ May '13
>><<>>;>
Former Boats:
- 2006 31TE / Hull# 221
Cummins QSC 8.3 / 500 hp
December '13 - April '23
- 2002 / 28TE / Hull# 614
Cummins 6BTA 370 hp / Alaskan Bulkhead
April '04 ~ May '13