I have a wonderful blue hull Albin 35 TE with Twin Cummins TBA 370 hp TBA 5.9 engines. I am trying to figure out the fuel capacity (how much fuel my tanks hold). I would like to determine this before I head out on a long range west coast Tuna trip.
Dose anyone know if it is a standard tank in all Albin 35 TEs? and if so, what is the capacity?
• Welcome to https://albinowners.net, the new home of Albin Owners Group!
• You will need to log in here, and you may want to bookmark this site. If you don't remember your password, use the I forgot my password link to reset it.
• All content has been transferred from our previous site.
• Contact Us if you have any questions or notice a problem. If you're not receiving our email, include a phone number where we can text you.
• You will need to log in here, and you may want to bookmark this site. If you don't remember your password, use the I forgot my password link to reset it.
• All content has been transferred from our previous site.
• Contact Us if you have any questions or notice a problem. If you're not receiving our email, include a phone number where we can text you.
FAQ:
• Membership information
• Burgees
• How to post photos
• Membership information
• Burgees
• How to post photos
Fuel Capacity Albin 35 TE
-
- Gold Member
- Posts: 28
- Joined: Sun Jan 24, 2016 1:05 pm
- Home Port: Sausalito
- DougSea
- Gold Member
- Posts: 2762
- Joined: Tue Jun 13, 2006 9:45 am
- Home Port: Safe Harbor - Essex Island Marina, Essex, CT
- Location: Essex, Connecticut
Re: Fuel Capacity Albin 35 TE
Sonny IV has three 125 gallon tanks plumbed together to give 375 gallons total. She fills from either side and draws/returns fuel from the center tank only. The fuel sender is also mounted to the center tank. You MAY be able to see the capacity plate on yours at the top rear of the tanks.
Being an Albin NOTHING is standardized, but I'd bet yours tanks are the same.
Being an Albin NOTHING is standardized, but I'd bet yours tanks are the same.
Doug
Sonny IV
2006 35TE Convertible, Volvo D6-370's
Former owner - Sonny III, 1997 28TE with "The BEAST"
Sonny IV
2006 35TE Convertible, Volvo D6-370's
Former owner - Sonny III, 1997 28TE with "The BEAST"
-
- Gold Member
- Posts: 28
- Joined: Sun Jan 24, 2016 1:05 pm
- Home Port: Sausalito
Re: Fuel Capacity Albin 35 TE
OK, I can see the center tank capacity sticker on the center tank and it says "Capacity 125 gallons" I am unable to see the top of the other tanks. I think I may have to measure the dimensions and do a little math to confirm.
- rcwhite
- Gold Member
- Posts: 163
- Joined: Mon Jul 28, 2008 7:05 am
- Home Port: Southport Maine
Re: Fuel Capacity Albin 35 TE
The outboard tanks are slightly smaller than the center tank in order to conform to the hull.
Total capacity is approx 360. The Albin specs say 369.
Pickups are pretty low. Port being the lowest based on which racor picks up the majority:)
I ran ours down to 20 gal prior to pulling the tanks.
Probably have pics somewhere
Total capacity is approx 360. The Albin specs say 369.
Pickups are pretty low. Port being the lowest based on which racor picks up the majority:)
I ran ours down to 20 gal prior to pulling the tanks.
Probably have pics somewhere
-
- Deckhand
- Posts: 8
- Joined: Thu Oct 12, 2017 7:00 am
- Home Port: Riverhead NY
- Location: Riverhead n y
Re: Fuel Capacity Albin 35 TE
I have a 2004 35' tie and the fuel capacity on that is 369 gallons spread between three tanks.
-
- Deckhand
- Posts: 7
- Joined: Mon Aug 12, 2019 9:55 pm
- Home Port: Stuart, Fla
Re: Fuel Capacity Albin 35 TE
I just talked to Luther’s Welding shop in RI (most probably the original manufacturer) as I am heading to survey this week on a 35TE. Jennifer was very helpful, “most likely a single 125 gal with 2) 113gal side tanks “ a little different then everything else I have read but could be a “Useable” number. With your hull number they can confirm exactly what they installed!!
Very impressive for a job done in 2002 (in my case)!!!
Additionally, she expected they would have been made out of 3/8” thick material, I didn’t have my hull # when I called.
I will when I call back!!
Fran
Very impressive for a job done in 2002 (in my case)!!!
Additionally, she expected they would have been made out of 3/8” thick material, I didn’t have my hull # when I called.
I will when I call back!!
Fran
Fran Wilson
Stuart, Fl
JDeere 2040, Kubota BX23, Ventrac, 28-6 BlueWater CC, 15-6 Hobie Skiff, C182
Stuart, Fl
JDeere 2040, Kubota BX23, Ventrac, 28-6 BlueWater CC, 15-6 Hobie Skiff, C182