no tach

[saltshaker28]

My tach which is a beede quit working yesterday all other gages are working fine any ideas what could be wrong

[RobS]

The spade connectors at the sender most likely need cleaning and tightening. It's a 2 wire sender located at the bellhousing (between the engine and tranny). It's straight down from the exhaust bend coming out of the turbo. An orange and a black wire. Clean the connections and if not a tight fit give them a light squeeze with some pliers to tighten the connector. Port side on an engine box, starboard on a FD. Photos have been posted here which should come up with the search function...

[sweetwater]

I would check the sensor at the flywheel, the connections tend to corrode/loosen.

[sweetwater]

Sorry... Rob beat me to it.

[saltshaker28]

thanks i will check that this morning

[saltshaker28]

Rob what word should I search for?

[RobS]

"sender"

here you go:

viewtopic.php?f=7&t=2803&hilit=sender

[saltshaker28]

Thanks Rob you are the best