2006 Albin 28 Sink

[kowal_53]

I need to replace my Albin 28 sink. It has 2 pin holes in it. The good news is I finally got it out. Those factory guys were not shaby on the silicone.

Does any one know where to get one?

[Nancy]

What size is your sink? It might be mistake to assume that they're the same across all years...

Ours are both 10.75" W x 13" L x 6" D including 1/2" flange. This one looks like a good possibility:

http://store.hamiltonmarine.com/browse. ... ,7710.html

In fact, this is the only one I've seen that are the exact dimensions, and I've looked at a lot of sinks.

[kowal_53]

The sink looks like the one. It is made by Sterling Pumbling Group. I ordered a new one, and I believe it will fit.

Thanks for the link, I was not having much luck until this responce came along.

[Nancy]

You're welcome. I'll be interested to hear how it fits.

[kowal_53]

I recieved the sink today, and it as identical as one would have hoped for. If any one out there needs a sink, this is the place to get it. Although is was not inexpensive, it did cost 1/2 of some of the others out here.

Thanks again for the link.

[Nancy]

Thanks for the followup. Glad it works!

[kowal_53]

If you need a new strainer, likeI did, you can get it from many RV stores, and few boat supply places. It is made by JR products # 9490-217-022