What is the deadrise of the hull in a Albin 28?

Post by **gerber30** » Thu Dec 24, 2009 9:18 am

I am getting ready to install a tilted element transducer in my 1997 Albin 28. Does any one know the dead rise of the hull at about the helm station? I can measure it but am not near the boat at this time. Let me know, Thanks

Post by **Russell** » Thu Dec 24, 2009 2:55 pm

If you are picking an Airmar you have a choice of 12 or 20 degrees. I had the 20 degree installed a few years ago and have been very happy with it. It is located just aft of the bulkhead between the pilothouse bilge and the cabin. Farther back the deadrise is less but I do not know what it is.

Post by **gerber30** » Thu Dec 24, 2009 5:14 pm

Thanks, that answers my question. I am installing a Raymarine product, but they use the same Airmar transducers. Thanks again.

Post by **Mariner** » Wed Dec 30, 2009 10:13 am

Hold a protractor up to the screen:

Albin Owners Group

Albin Owners Group

What is the deadrise of the hull in a Albin 28?

What is the deadrise of the hull in a Albin 28?

Re: What is the deadrise of the hull in a Albin 28?

Re: What is the deadrise of the hull in a Albin 28?

Re: What is the deadrise of the hull in a Albin 28?