Raymarine C80 display problem
Posted: Fri Jun 15, 2018 6:15 pm
I have a RayMarine C80 multi display. It works intermittently and then will go off/dark spontaneously .....I called RayMarine Tech support and they are helpful. I have a good power cord and the voltage is good at the display connection. Tech Support suggested (and I have read elsewhere) that it could be a loose "jockey board". Tech Support suggested that I get some Silicon ll and put it around and under the jockey board if it is loose.
PROBLEM....I don't know what the "jockey board" looks like. I have the display apart and have the board with all of the transistors, etc, exposed. Not sure which component is the "jockey board"
Can anyone describe it? I have a lot of round components....a square yellow one that says "high voltage"...there are a couple ribbon connectors that are bronze in color. Someone on another post some months ago thought that a ribbon connector with corrosion could explain this........
So, what is the jockey board; where is it and what color is it? How to determine if it is loose? Any other suggestions.
Thank you.....
PROBLEM....I don't know what the "jockey board" looks like. I have the display apart and have the board with all of the transistors, etc, exposed. Not sure which component is the "jockey board"
Can anyone describe it? I have a lot of round components....a square yellow one that says "high voltage"...there are a couple ribbon connectors that are bronze in color. Someone on another post some months ago thought that a ribbon connector with corrosion could explain this........
So, what is the jockey board; where is it and what color is it? How to determine if it is loose? Any other suggestions.
Thank you.....