I started by changing the oil. The specs say it holds seven gallons, but I only took out about 5, including the filter. It also took about 5 gallons to bring fill it back up. That doesn't really surprise me, but I'm a little concerned because the "full" mark is just a home-made scratch mark on the dipstick. The dipstick doesn't appear to have any OEM markings on it, so I don't know if it's really full or not. Regardless, it shows good oil pressure (50-52psi at idle) and I'm not worried. (engine is a Cat 3126B)
My next project was to install a RAM Mic for our Standard/Horizon Spectrum VHF radio. This is a second station with limited controls right on the microphone that is located on the flybridge. I didn't quite finish this project as I ran out of daylight, but I will finish it soon.
The biggest change was to tie the boat's four golf cart batteries (previously used only for powering the Freedom 25 inverter), into the house panel. The boat has two 8D deep cycle batteries; one for starting and one for house loads. To accoplish the job of combining and isolating these batteries, while still allowing each to do their job independently, Albin utilized a set of two, three-position switches. One switch was labeled "ENGINE" and one was labeled "HOUSE". Basically they each had the battery attached to the "2" terminal, and then had a link running between them attached to the "1" terminal" on each switch. By switching both switches to "2" they were isolated. You could start the engine (or charge the battery), and use house loads, but they would not draw each other down. By switching them both to "ALL", they were combined for charging.
This was fine except that I still had this bank of golf cart batteries sitting back there that could only be used to run the inverter. They did not tie into the 12V panel at all. So I started looking at ways to incorporate it safely. What I ended up doing was simply connecting it to the "1" terminal" on the "HOUSE" switch. I then moved the link wire from the "1" terminal over to the "2" terminal on the same switch. I can still isolate them by turning the "ENGINE" switch to "2", but now I have the ability to draw on the golf cart batteries for house loads (lights, refrigeration, electronics, etc...).
This does require some careful use of the battery switches, and I have drawn up a wiring diagram and some switching instructions (not all users of the boat understand this as well as me). However, I want to add an automatic charging relay between house and start batteries and eliminate the cross link at the switches, to make the switching easier and more idiot-proof.
This is the wiring diagram of what it was like prior to the modification:

And here it is after:

Anyway, I just thought I'd share this with everyone. I will provide updates as to it's success or failure.